Artificial grass is an alternative to a natural lawn. People invest in artificial grass because of its minimal maintenance. It saves you time and energy, which you can spend doing other things.
Moreover, fake grass is environmentally friendly. The environment will be more sustained if you use artificial turf than break rocks for a lawn. Aside from being eco-friendly, artificial turf is safer for children as it prevents the risk of dirty paw prints and tracks entering the house.
Many people believe that using artificial turf requires no maintenance. However, that is not the case. While synthetic turf does not require watering or mowing like a natural lawn, there are some maintenance requirements to keep your grass in good condition. Here are some tips on how you can maintain your artificial grass.
1. Bush your lawn to look natural
The sand infill is used to support artificial lawns when they are installed. It takes approximately 6 to 8 weeks for the synthetic grass to settle. After that, it will require very little maintenance. It is essential to brush the artificial grass during this first period lightly.
Even though it may seem like a small task, brushing your lawn will make a big difference in the status and appearance of your property. You may need to brush more often in areas with high foot traffic to keep your lawn’s blades from becoming flattened or trampled.
2. Remove debris and stains
Artificial turf is composed of synthetic fibres impervious to dirt, water, and other substances, which simplifies maintaining your lawn. Stains are inevitable as spills, animal waste, and debris are bound to happen.
Rainfall is considered an effective way to cleanse your fake grass yard. However, if you live in an area with less rain, a quick spray with a hose will periodically eliminate collected dust. Additionally, it can assist in removing dried and hardened organic debris.
3. Keep your grass odour-free.
Even if you immediately attend to a spill, a foul odour will stay on your grass. Therefore, it would be better to install sprinklers to drain any waste from pets and cool the grass off. To remove existing odours, you can use DIY cleaning solutions, including baking soda, water, or vinegar. Clean your grass regularly to check if there is waste, causing a foul smell on your fake lawns.
4. Get rid of bacteria and mould.
Spots of colour typically indicate that mould is forming in your artificial grass. Address this with hydrogen peroxide and immediately clean it with water to avoid chemical damage.
Bacteria thrive in areas where your pet urinates frequently. Clean it with a vinegar and water solution. You can use your garden hose to evenly spray the mixture over the whole lawn if you want to see it.
5. Schedule your cleaning tasks.
Individuals should maintain artificial grass twice per month. If you have pets or children at home, you need to care for your artificial grass more often. If your artificial lawn is heavily used for sports, the same measures apply. High-traffic areas should be maintained when you are likely to be out in your garden during the summer.
Conclusion
These are easy tips when maintaining artificial grass. Hence, it is essential to maintain and maximize its longevity to achieve a worthwhile investment. It would be better to find a quality and reliable artificial grass provider that will assist you in keeping your synthetic lawn.
You can always choose and rely on Easy Turf for more crucial information on premium synthetic grass solutions for your yard or lawn. We offer quality and life-like turf suitable to Australia’s harsh climate conditions. It can also provide quality artificial grass installation for commercial, sporting, and residential landscapes. Contact us at 1300 475 499 or 1300 475 499 or visit our artificial grass shop to learn more about our products.
Commonly asked Artificial Turf Questions
Why should you go with Easy Turf for your artificial turf?
We are an industry leading supplier and installer of high quality artificial grass in Australia. As industry experts we can give you the best advice for when you are laying your synthetic grass. Installing artificial turf can provide a rewarding experience to your family and household as it frees you from the hassles and expense of owning a traditional lawn.
If you have any questions on artificial grass, we are happy to help answer any of your questions around the installation of your synthetic grass. How to get in contact? Reach us on 1300 475 499 or, at https://www.easyturf.com.au/contact-us.
We have a step by step guide on laying your synthetic grass into simple steps. The guide will run you through:
- Getting ready – your checklist
- Measuring up for synthetic grass
- Choosing the right grass for you
- Preparing the ground for your synthetic grass
- Rolling and pegging out your grass
Expert tips for natural-looking artificial grass
Why you should double check your Artificial Turf measurements
When measuring up for artificial grass installation it’s crucial to know exactly how much artificial turf you are going to need for your project. Just imagine being short a few square metres on your project or you have massively over-ordered your artificial turf. Double check your measurements and also ensure you order slightly more artificial turf than you think in case there is miscalculation or errors.
How do you prepare the ground for synthetic grass?
Preparing the base so that it is rubble-free, smooth and flat is essential to the success of your DIY turf-laying project. Skip a step and you risk unwanted lumps and bumps.
Remove any existing turf and soil including any stones, pebbles and debris. We suggest you dig to around 7.5cm deep.
- To prevent any regrowth from weeds and unwanted plants, place a plastic membrane over the entire cleared area.
- Apply a thin layer of crushed stone over the top of the plastic membrane.
- Use planks of wood to create a new layer over the top of the crushed stone.
- If you are laying your artificial grass over the top of concrete or paving stones, it’s essential to check that it is level. If not, you will need to use a spirit level and create extra height with additional concrete or other materials. You will also need to make sure that there is adequate drainage close by to handle excess rain and water.
- We recommend that you use a foam underlay on the top of the concrete to create a more comfortable feel underfoot. Easy Turf suggests using 5mm of foam underlay on top of concrete and pavers to give some softness.
- Use a compactor where necessary to ensure a level and robust finish to your foundations.
How to roll out and peg your synthetic grass
Once you have the foundations in place, it is time to peg out your turf, a crucial step before you permanently fix it into position. Follow these steps to ensure the best results.
Slowly unroll your synthetic turf over the carefully prepared foundations.
Use your nails and/or pegs and place at even intervals along the turf but about 30-40cm from the edge to hold it in place (the space between the nail and the edge of the grass will be held down by the adhesive tape used in step D).
If you are using artificial grass on concrete, paving stone or hard floor, use industrial-strength synthetic turf glue instead of nails. As before, leave a gap of approximately 30-40cm to the edge of the grass to allow for the use of tape.
Add the next strip of artificial grass and use the same principles, either nailing/pegging or glueing in place and leaving the space to allow for taping.
As you lay the consecutive strips, be careful to ensure that the pile of the grass is running in the same direction (if the fibres are pointing in alternate ways you will have an uneven stripe in your grass). If in doubt, use your hand to feel which way the threads are pointing.
Once you have covered all your area with synthetic turf you are ready for the next step. Use your industrial strength tape to connect adjoining grass strips. Apply tape along the entire length of one piece of grass and then ‘connect’ the section next to it by laying that on top of the remaining tape. Flatten and ensure that it is a tight fit without any gaps or unstuck areas.
What is the purpose of sand on artificial grass?
- The sand helps the ‘roots’ of the synthetic grass to stay upright, regardless of use; this avoids the grass appearing to flatten on high traffic areas.
- As the sand helps the grass to remain upright it does create a variation on the angle that they point which resembles the blades of real grass.
- Sand helps to prevent a flattening of the blades in high traffic areas.
- Using the correct type of sand (only use artificial turf white sand) allows for excellent drainage without washing away the sand or soaking up excess water.
- The sand remains within the turf and doesn’t rub off on clothing or on kids and pets who choose to roll on the grass.
No time for DIY?
We understand that even though you might prefer to install your artificial grass you don’t have the time. We understand if, due to time constraints (or you don’t like DIY), that you’d prefer that the other experts (us) did the job and you get to spend the weekend trying out your new lawn. No worries.
Easy Turf is happy to provide installation and supplier services and take away yet another hassle. As well as supplying samples of our range of artificial grass, we can also provide quotes and have a register of approved installers of our artificial grass in Australia. Select your State and you will see a list of our recommended suppliers and installers.
Contact EasyTurf today and let us help you choose from the best artificial grass in Australia. We pride ourselves on our excellent customer service with honest and reliable advice. Contact us for a quote or more information sales@easyturf.com.au
What supplies do you need to lay Artificial turf?
In order to have a hassle free synthetic lawn installation you need to make sure you’ve done the prep work. Here is a handy checklist to make sure you have all the things you need:
- Grass – Choosing the right grass for your yard is important for your enjoyment. We offer a wide range of synthetic grasses that are designed to look & feel just like real grass.
- Pegs and nails to hold down the grass and prevent movement
- Industrial gloves – to protect your hands
- Peel and stick tape – to join synthetic grass together and provide a neat finish
- Industrial strength synthetic grass glue – ideal if you are putting your lawn on top of concrete, pavers or other hard surfaces
- Artificial grass sand and fine rock – for a reliable base and for finishing off the prep
- Foam underlay – if you are using grass on hard surfaces such as concrete and pavers
- Wooden planks – to help flatten the earth
- Compactor (either manual or machine-driven) – to flatten the ground and ensure a professional finish
- Standard tools such as a broom, rake, hammer, spirit level, hose, retractable tape measure, nails, quality retractable or fixed blade knife
How to choose the right synthetic grass for you?
Once you have the correct measurements for your artificial grass, you need to select which type of synthetic grass will be best for your project. Easy Turf has a wide range of fake grass available that is suitable for residential, educational, sports, and commercial applications. We offer free samples and also partner with local wholesalers.
Can I Lay Fake Grass On Dirt
It’s not advisable to lay fake grass on topsoil or any sort of soil. This will leave you with an uneven finish for your freshly installed artificial grass, and also have weeds slowly grow in over time.
For the best results follow our DIY Guide for installing fake grass.
How To Lay Artificial Grass On Sand
Artificial grass cannot be placed only on sand, as you need to use crushed rock to assist with the drainage and ensure that the synthetic grass stays level.
For the best results follow our DIY Guide for installing fake grass.
Why use silicon sand with your artificial grass?
Once you’ve laid your artificial grass you have two options in your next steps. You can either leave the grass as is or add sand to make it appear more natural.
Adding sand to the grass can help it appear more natural as it helps keep the grass upright. To add the proper amount of sand ee recommend that you allow for approximately 10-15kg per sqm for coverage. Using a rake or a broom, sprinkle the sand on top of the grass and walk it in to make sure that it falls deep down into the pile and settles at the base. Then, water the lawn to help the sand settle down within the grass.
