Sports Artificial Grass Photo Gallery

We are an industry leading supplier and installer of high quality artificial grass in Australia. As industry experts we can give you the best advice for when you are laying your synthetic grass. Installing artificial turf can provide a rewarding experience to your family and household as it frees you from the hassles and expense of owning a traditional lawn.

If you have any questions on artificial grass, we are happy to help answer any of your questions around the installation of your synthetic grass. How to get in contact? Reach us on 1300 475 499 or, at https://www.easyturf.com.au/contact-us.

We have a step by step guide on laying your synthetic grass into simple steps. The guide will run you through:

• Getting ready – your checklist
• Measuring up for synthetic grass
• Choosing the right grass for you
• Preparing the ground for your synthetic grass
• Rolling and pegging out your grass 

Expert tips for natural-looking artificial grass

When measuring up for artificial grass installation it’s crucial to know exactly how much artificial turf you are going to need for your project. Just imagine being short a few square metres on your project or you have massively over-ordered your artificial turf. Double check your measurements and also ensure you order slightly more artificial turf than you think in case there is miscalculation or errors.

Preparing the base so that it is rubble-free, smooth and flat is essential to the success of your DIY turf-laying project. Skip a step and you risk unwanted lumps and bumps. 

Remove any existing turf and soil including any stones, pebbles and debris. We suggest you dig to around 7.5cm deep.

1. To prevent any regrowth from weeds and unwanted plants, place a plastic membrane over the entire cleared area. 
2. Apply a thin layer of crushed stone over the top of the plastic membrane.
3. Use planks of wood to create a new layer over the top of the crushed stone. 
4. If you are laying your artificial grass over the top of concrete or paving stones, it’s essential to check that it is level. If not, you will need to use a spirit level and create extra height with additional concrete or other materials. You will also need to make sure that there is adequate drainage close by to handle excess rain and water.
5. We recommend that you use a foam underlay on the top of the concrete to create a more comfortable feel underfoot. Easy Turf suggests using 5mm of foam underlay on top of concrete and pavers to give some softness.
6. Use a compactor where necessary to ensure a level and robust finish to your foundations.

Once you have the foundations in place, it is time to peg out your turf, a crucial step before you permanently fix it into position. Follow these steps to ensure the best results.

Slowly unroll your synthetic turf over the carefully prepared foundations.
Use your nails and/or pegs and place at even intervals along the turf but about 30-40cm from the edge to hold it in place (the space between the nail and the edge of the grass will be held down by the adhesive tape used in step D).
If you are using artificial grass on concrete, paving stone or hard floor, use industrial-strength synthetic turf glue instead of nails. As before, leave a gap of approximately 30-40cm to the edge of the grass to allow for the use of tape.
Add the next strip of artificial grass and use the same principles, either nailing/pegging or glueing in place and leaving the space to allow for taping.
As you lay the consecutive strips, be careful to ensure that the pile of the grass is running in the same direction (if the fibres are pointing in alternate ways you will have an uneven stripe in your grass). If in doubt, use your hand to feel which way the threads are pointing.
Once you have covered all your area with synthetic turf you are ready for the next step. Use your industrial strength tape to connect adjoining grass strips. Apply tape along the entire length of one piece of grass and then ‘connect’ the section next to it by laying that on top of the remaining tape. Flatten and ensure that it is a tight fit without any gaps or unstuck areas.

• The sand helps the ‘roots’ of the synthetic grass to stay upright, regardless of use; this avoids the grass appearing to flatten on high traffic areas. 
• As the sand helps the grass to remain upright it does create a variation on the angle that they point which resembles the blades of real grass. 
• Sand helps to prevent a flattening of the blades in high traffic areas.
• Using the correct type of sand (only use artificial turf white sand) allows for excellent drainage without washing away the sand or soaking up excess water. 
• The sand remains within the turf and doesn’t rub off on clothing or on kids and pets who choose to roll on the grass.

We understand that even though you might prefer to install your artificial grass you don’t have the time. We understand if, due to time constraints (or you don’t like DIY), that you’d prefer that the other experts (us) did the job and you get to spend the weekend trying out your new lawn. No worries.

Easy Turf is happy to provide installation and supplier services and take away yet another hassle. As well as supplying samples of our range of artificial grass, we can also provide quotes and have a register of approved installers of our artificial grass in Australia. Select your State and you will see a list of our recommended suppliers and installers.

Contact EasyTurf today and let us help you choose from the best artificial grass in Australia. We pride ourselves on our excellent customer service with honest and reliable advice. Contact us for a quote or more information sales@easyturf.com.au